Recent content by Chris611

Good point. I belive there is an SAE spec for the tooth dimensions. I will look it up and reference it when I get back to the office tommorrow. Thanks Chris

1) 6061 - T6 2) Mat'l and shipping to 50138 (Knoxville, IA) to be included in the quote. 3) Qty: 1 4) Drawing is attached 5) Time Frame - 10 days from acceptance 6) RFQ ending time - 5/8/09 Details: This is a 24 Tooth (1.528 PD) 1/5" XL Timing Pulley. I have it drawn as an...

Thanks guys, I will try and see if I can simplify the part and get the cost down. -Chris

Am I understanding you right, that Al would be cheaper to machine than steel? Why is that? Is it the speed at which it can be machined vs the extra cost of the material? Any help would be appreciated. Are there details on the part that make it hard to machine? I can try and address some of...

Hello. This is my first post on this board. I am looking to have a piece machined for some gauge mounts. I am attaching a .pdf file. However I can send other file formats including the model. It was modeled using SW2005. If there is any other additional information, please feel free to...