Small Job Quote Needed 6pcs/ 360x167mm/ 4mm Aluminum Panel

[butterbee]

Black anodized 4mm Aluminum. Some holes are milled for counter sinking. There are a few edge cavities (reverse side).

I need one each of the attached DXF files (except 2 of file named "2011_07_sidePanels"). That is a total of 6 pieces, the largest 2 being 360 x 167mm.

Please contact via email. Thanks.

 

[Grass Roots]

Hello, Would appreciate a chance to quote this job. I could quote both ways; without anodizing and with. Please Email, cduginski@new.rr.com Thank You

Can you provide pdf files rather than dxf files?

 

[fullbore]

Hello, Ive looked at your project and would like the opportunity to quote. Could you please send me an e-mail and I will reply with a quote.

Thank you

 

[Grass Roots]

Hello, One question before I offer a quote. Do you want the lettering and numbering put in on the top panel? If so stamped, etched engraved or by any other means?
The machining itself would be straight forward and very reasonable. Thank You.