Parts for my small project - 16 parts in all

Status
Not open for further replies.

josephmartins

Geek n Gearhead
Good afternoon all,

I moved this RFQ from the manual machining section. I had originally planned to have the parts machined, but the cost was too high. So I am hoping to fabricate the parts via welding instead.

I have redesigned the parts to make use of some standard-sized square and cylindrical tubing. There are three types of parts. I call them the collar, sleeve and pivot.

1) Material type. I'd prefer to use aluminum (6061 or 7025), but only if you have the ability to retreat the parts after welding. If not, steel would be fine for the prototype.
2) Is a material quote required or is material supplied. Quote with material please.
3) Quantity I need 2 sleeves, 2 pivots and 12 collars.
4) Images attached as JPGs. Can provide dimensioned PDFs if that'd be easier.
5) Required time frame No rush. If I can get the parts by Jan/Feb that'd be great.
6) RFQ ending time open until I find someone to do the job
 

Attachments

  • pivot.jpg
    pivot.jpg
    91.4 KB · Views: 184
  • sleeve.jpg
    sleeve.jpg
    77.5 KB · Views: 136
  • collar.jpg
    collar.jpg
    88.6 KB · Views: 133

SMWMACHINEWORKS

New Member
My email is santschi.1@att.net, I can work on a quote with just the jpg but the pdf would be best. I have a machine and welding shop so this is right up our alley. If you email me I can the call you or you can call me so I can check the details.
Thanks, Bryan
 
Status
Not open for further replies.
Top