Awarded Quote Qty20 Polycarbonate Plastic Parts - Closes 10/15

Status
Not open for further replies.

rfqjon

New Member
Thank you for your review of this RFQ:
1) Material type is Makrolon Polycarbonate Plastic - http://www.plastics.bayer.com/en/Products/Makrolon.aspx
2) I will provide the stock material (12"x10"x.495")
3) Quantity requested in quote is 20 - this work will re-occur occasionally
4) Drawings/Prints located at: https://drive.google.com/drive/folders/0ByZgsecbYqQ7NWJjNnluU2kxT1U?usp=sharing
5) 2 Week Turnaround requested for parts – not INCL shipping time
6) Quotes must be received by 10/15/2020
7) Parts profile cut from ~.5” stock from supplier – finishing to the .495” tolerances thickness is not required (as shown in document).
8) Chamfer can be manually applied – limiting sharp edges is what matters most

The link to drawings above contains PDF, DWG, STL, IGES parts.
I’ve had success on RFQWORK getting parts completed in the past, and I hope to do the same this time.

Please contact me if you need clarifications, or a drawing format that is not currently posted.
 

Chad

New Member
Thank you for your review of this RFQ:
1) Material type is Makrolon Polycarbonate Plastic - http://www.plastics.bayer.com/en/Products/Makrolon.aspx
2) I will provide the stock material (12"x10"x.495")
3) Quantity requested in quote is 20 - this work will re-occur occasionally
4) Drawings/Prints located at: https://drive.google.com/drive/folders/0ByZgsecbYqQ7NWJjNnluU2kxT1U?usp=sharing
5) 2 Week Turnaround requested for parts – not INCL shipping time
6) Quotes must be received by 10/15/2020
7) Parts profile cut from ~.5” stock from supplier – finishing to the .495” tolerances thickness is not required (as shown in document).
8) Chamfer can be manually applied – limiting sharp edges is what matters most

The link to drawings above contains PDF, DWG, STL, IGES parts.
I’ve had success on RFQWORK getting parts completed in the past, and I hope to do the same this time.

Please contact me if you need clarifications, or a drawing format that is not currently posted.
 

José baca

New Member
Thank you for your review of this RFQ:
1) Material type is Makrolon Polycarbonate Plastic - http://www.plastics.bayer.com/en/Products/Makrolon.aspx
2) I will provide the stock material (12"x10"x.495")
3) Quantity requested in quote is 20 - this work will re-occur occasionally
4) Drawings/Prints located at: https://drive.google.com/drive/folders/0ByZgsecbYqQ7NWJjNnluU2kxT1U?usp=sharing
5) 2 Week Turnaround requested for parts – not INCL shipping time
6) Quotes must be received by 10/15/2020
7) Parts profile cut from ~.5” stock from supplier – finishing to the .495” tolerances thickness is not required (as shown in document).
8) Chamfer can be manually applied – limiting sharp edges is what matters most

The link to drawings above contains PDF, DWG, STL, IGES parts.
I’ve had success on RFQWORK getting parts completed in the past, and I hope to do the same this time.

Please contact me if you need clarifications, or a drawing format that is not currently posted.
 
Status
Not open for further replies.
Top