Hi guys I’m working on a 67' ChevII and I’m doing a custom 3 link on it. Im replacing the frame rails and adding a cross member to mount the links to. Now I have the x member and the frame rails tacked in. I was looking at the whole deal and it looks like I can drop the whole pig out. My question is: now that I have the rear rails and x member tacked and measured out for the car, can I remove the whole unit and complete it out of the car? Or should I just weld it up in the car? Some of the parts I need to get to and weld are very hard to reach, this would make it alot easier as you can imagin. Request assistance please
Rear frame fabrication
- Thread starter thomas45
- Start date
- Status
Morrison Machine Shop
Michael Morrison
If you have everything tacked well, then I would drop it and go to welding, making sure everything is in place and doesnt move.
- Status