This is a small job, only two pieces, not very complicated. I'm looking to have an emblem made for my motorcycle tank (one piece on both sides, so two pieces). Here's what I need:
Attached is a JPG (for viewing) and a DWG of the emblem. Specs are:
- 5052 Aluminum (or whatever grade you may have around that will work fine), brushed.
- 8.5" L x 1.5" W
- .25" thick
If the design can be almost completely routed out instead of being routed/etched into a rectangular block it would be preferred, but I will listen to whatever opinions you guys have for me... you are the masters!
There is more talk about this design HERE. Please take a look and see if this answers any questions you may have.
Thanks!!!
Attached is a JPG (for viewing) and a DWG of the emblem. Specs are:
- 5052 Aluminum (or whatever grade you may have around that will work fine), brushed.
- 8.5" L x 1.5" W
- .25" thick
If the design can be almost completely routed out instead of being routed/etched into a rectangular block it would be preferred, but I will listen to whatever opinions you guys have for me... you are the masters!
There is more talk about this design HERE. Please take a look and see if this answers any questions you may have.
Thanks!!!
Attachments
Last edited: