Small Job Quote Needed 25 pcs - ABS Plastic Case Milling

[rpcelectronics]

I have a small job that I need to have done in the next few weeks. The product uses a standard Pactec ABS plastic case. Two halves, with a removable end panel. The milling requires one of the halves and the end panel to be milled.

This is a first run, with the potential for more, if the product takes off.

I have .dwg and .dxf files drawn up. They may need to be tweaked before milling. I am willing to make those changes to the drawing, but they should be enough to quote the job. The .dxf files are attached, I can provide the .dwg files, if needed.

We will provide the cases.

I can be directly contacted at jason (at) rpc-electronics.com

Thanks!
Jason Rausch
RPC Electronics, LLC
www.rpc-electronics.com

 

[rpcelectronics]

I have corrected the .dxf files and uploaded them to this thread.

I need to have these milled parts back by Sept. 10 (9/10/11).

 

[rpcelectronics]

This job has been awarded. Thanks to all who submitted a quote!