Two parts needed.
1) Material type: 6061 al
2) Include material and usps flat rate shipping
3) Quantity
Blanks 50
Rings 100
5) Required time frame: ASAP
6) RFQ ending time: I would like to get this taken care of today 7-31-09 but I will see what kind of replies are given.
Jake@Motoworxracing.com
Canon City CO
81212
More info.
Blanks: qty: 52
I am thinking these could be made with a CNC Lathe with a cutoff tool. I have made these manually by bandsawing and then facing off both sides. If having a hole through the center of the blanks helps the cut off process then that can also be done. If it doesn't help than it is not necessary.
The small hole on the outer edge I also have done manually. If you have a better way than please include that hole. If not and you have to set up a second operation than don't worry about it.
Rings: qty: 104
Rings have a thickness of .100"
Again I did these manually by drilling the center hole and parting off in a lathe. I would deburr the outer edges as the tool was cutting in. I also would feed the tool back out taking a very light finishing cut so it would leave the outside of the ring with a very good finish. Then I would put them in my cnc mill. Can a cnc lathe with live tooling do this in one step?
If you have a finishing machine like a vibratory tumbler; I would like to know the cost of finishing the rings only. It is not necessary for the blanks as they get further machined.
Thanks for your time
Jake
Motoworx MFG.
1) Material type: 6061 al
2) Include material and usps flat rate shipping
3) Quantity
Blanks 50
Rings 100
5) Required time frame: ASAP
6) RFQ ending time: I would like to get this taken care of today 7-31-09 but I will see what kind of replies are given.
Jake@Motoworxracing.com
Canon City CO
81212
More info.
Blanks: qty: 52
I am thinking these could be made with a CNC Lathe with a cutoff tool. I have made these manually by bandsawing and then facing off both sides. If having a hole through the center of the blanks helps the cut off process then that can also be done. If it doesn't help than it is not necessary.
The small hole on the outer edge I also have done manually. If you have a better way than please include that hole. If not and you have to set up a second operation than don't worry about it.
Rings: qty: 104
Rings have a thickness of .100"
Again I did these manually by drilling the center hole and parting off in a lathe. I would deburr the outer edges as the tool was cutting in. I also would feed the tool back out taking a very light finishing cut so it would leave the outside of the ring with a very good finish. Then I would put them in my cnc mill. Can a cnc lathe with live tooling do this in one step?
If you have a finishing machine like a vibratory tumbler; I would like to know the cost of finishing the rings only. It is not necessary for the blanks as they get further machined.
Thanks for your time
Jake
Motoworx MFG.
Attachments
Last edited: