rfqmechmags
New Member
1) Material type: ALuminum 7075 or sim, steel is a consideration
2) Is a material quote required or is material supplied: Quote required/preferred
3) Quantity: 1 to verify prototype, followed by a small production run
4) Drawings should be immediately available or necessary specs.: Attached, pdf and or dwg file available upon request
5) Required time frame: ideally prior too 11/23/07 time flexible
6) RFQ ending time: 11/23/07 but this is an open ended project until i get functional protoype
I have little to no knowledge in metal work. This concept to me includes drilling, cutting and bending based off a material thickness of .0625. These plates will be slaving/combining two independant items into a single actuation device. There will be light stresses involved during end use so the plates need to be structurally sound with no apparent flex.
2) Is a material quote required or is material supplied: Quote required/preferred
3) Quantity: 1 to verify prototype, followed by a small production run
4) Drawings should be immediately available or necessary specs.: Attached, pdf and or dwg file available upon request
5) Required time frame: ideally prior too 11/23/07 time flexible
6) RFQ ending time: 11/23/07 but this is an open ended project until i get functional protoype
I have little to no knowledge in metal work. This concept to me includes drilling, cutting and bending based off a material thickness of .0625. These plates will be slaving/combining two independant items into a single actuation device. There will be light stresses involved during end use so the plates need to be structurally sound with no apparent flex.