Mike_Tucson
New Member
This is a capping chuck. We expect to build 3 but, only want to start with 1 to verify fit/function. We just had one built that did not work right. View attachment Capper Chuck.pdf
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Request For Quote- Lathe/mill/spline job
- Thread starter Mike_Tucson
- Start date
- Status
- Not open for further replies.
Mike_Tucson
New Member
Private message sent
Just came across this. Do you still have a requirement?Private message sent
Jim
Mike_Tucson
New Member
Yes, we are still taking quotes.
david williams
President
Is this all the information that you can give on the spline. What is the pitch and the pressure angle of the spline. The pitch and pressure angle, and the number of teeth is the best way to get a correct spline.
- Status
- Not open for further replies.