Wire Forming / Bending

Status
Not open for further replies.
C

cincy-gearhead

New Member
Anyone capable of forming (bending) 1/8 inch diameter stainless steel rod into different shapes? Finished part will be flat, symmetrical and small (fits in the palm of your hand). Like to find a source in Cincinnati or close by.

Have a project requiring 20 – 50 parts (all the same) for a first production run.

Thanks, Mark
 
C

cincy-gearhead

New Member
Thanks for responding but I think I found a simpler (standard part) solution. I'll keep you in mind if I have to go with a special. Thanks again, Mark
 
Status
Not open for further replies.
Top