Recent content by stang5197

Yeah that was very cheap. I bid $31.10 per 20, and that was based on +/-0.003 tolarance (including the thickness)

What was the price they got farmed out for?

Yes I appologize for the confusion the 3rd part is listed under the turning section.

Yes I apologize for the confusion the 3rd part is listed under the lathe section.

Attached are two prototype parts that we need machined. Our current prototype shop is not able to keep up right now. All of the part(s) are to be machined from 6061 aluminum Qty. Vent Push On Fitting 10pcs Note the Vent Clamp Top and Vent Clamp Bottom are mirrored, with the...

Attached are three prototype parts that we need machined. Our current prototype shop is not able to keep up right now. All of the parts are to be machined from 6061 aluminum Qty. Vent Clamp Top 5 pcs Vent Clamp Bottom 5pcs Date Required: 2 weeks after receipt of P.O. Note the Vent Clamp...

This job has been farmed out to a member of the board, thankyou for those that have quoted.

We need to have 225 pcs. machined ASAP. The material is 4140 (shop should supply the material). Qty. is 225 The knurling length is not critical, however it must uniform for all of the pcs. Any length between 0.2120" to 0.3600" will be fine (just need to be the same for all of the pcs.). The...

Thanks for all of the quotes, the job has been sourced to a member on this board. Thanks

I am looking for a RFQ for the following part. Plate Is Made from 1018 Steel; Qty. 20 pcs. Please PM the quote to me. Also we are looking for the work to be done with in the US. Thanks

Thanks for all of the quotes on these two parts. We have contracted the work to a user of this board. Thanks for you time.

Sorry I don’t have the AutoCAD print for these parts, but attached is a "snapshot" of the Cadd Drawing. What I am looking for is a quote on the two parts based on a order qty. of 25 pcs. Of each part. If we agree on a price, what I would do is send you a sample set of parts so you can see...